MVX6000 Voltage Isolation
& Waterproofing Membrane
MVX6000 is a Contact Voltage Isolation and Waterproofing Membrane (CVIM) specifically formulated to prevent the transfer of static electrical current through concrete slabs and walls in both dry and wet conditions. Whilst suitable for a wide range of uses, MVX6000 helps protect passengers and workers boarding or working on electrified rail systems. It is a vital component in protecting passengers from static discharge where platform screen doors are installed.
With a thickness of 2.5mm the MVX6000 has a volume resistivity of 6.17 x 10^14 ohm-cm and out performs all other known voltage isolation membranes of the same thickness.
Comprising a specially formulated butyl rubber membrane which contains neither bitumen nor bentonite, the MVX6000 has a self-adhesive base layer for bonding the membrane to differing substrates such as concrete slabs and metalwork. This self-adhesive side of the membrane provides an instant high-strength bond to the surface of most major construction substrates.
The upper layer of MVX6000 incorporates a non-woven polyester fleece surface layer. This layer allows the application of a variety of finishing materials including concrete and screed toppings as well as chemical and fire proof cement based materials. Through this
fleece layer, the concrete and screed toppings will form a high-strength bond to the membrane and indirectly though the membrane's self-adhesive layer to the underlying slab or other substrate.
Similarly a high-strength bond will be formed with plaster, render, cementitious coatings, resins, paints, tile adhesive and other similar materials applied in vertical and overhead planes.
This fully bonded system prevents delamination between the substrate and the topping which helps maintain the integrity of the floor, wall, column and ceiling finishes.
MVX6000 also helps isolate finishes zones from movements in underlying substrates as it offers high crack-bridging characteristics up to 3mm. The flexibility of the butyl core absorbs these deflections and helps prevent substrate cracking from transferring through to fragile applied finishes.
ADVANTAGES
-
Fast installation, just peel-and-stick application
-
No torch-on or hot air needed for installation
-
Excellent adhesive properties over a variety of surfaces with the use of MVX WB Primer
-
Readily conforms to irregular surface profiles
-
Does not contain bitumen making it more environmental friendly
-
Does not contain bentonite which is liable to dissolve in entrapped water and reduce the effectiveness of the isolation membrane
-
Excellent double bond to substrate and toppings
AREA OF USE
-
Electrified rail depot
-
Platform screen doors at railway station platforms, walls and colums
-
Viaducts and bridges
-
Power stations, electrical sub-stations and other utilities
-
Electrical riser rooms
-
Location where embedded electrical conduits are installed
-
Electrical isolation of metalwork such as expansion joints, control joints and other conductive materials that pass through electrically isolated areas
-
Petrol chemical plants and holding tank areas
TUTORIAL
Watch our full application video or download our Technical Data Sheet for this product.
MVX6000:
MVX WB Primer: